Keep the building warm in the winter and cool in the summer
with little to no utility bills / fossil fuels.
This increases both psychological and physiological comfort.

Both the International Building Code and the International Residential Code have requirements for maintaining a minimum temperature in buildings. They do not have requirements for a maximum temperature in buildings though there are ventilation system requirements and there are reasonable standards for comfort.

“All design projects should engage the environment in a way that dramatically reduces or eliminates the need for fossil fuel.”
The 2010 Imperative, Edward Mazria,AIA, Founder of Architecture 2030

passive solar and thermal dynamics

Passive solar technologies absorb heat from the sun via thermal mass (water, rock, stone, mud, etc.), cause ventilation via cooling tubes and operable windows with little use of any electrical energy.

Every south-facing window creates a direct-gain system, while windows facing east, west, and north lose more heat than they gain in the winter. The greenhouse effect, acts as a one-way heat valve. It lets the short-wave solar energy enter but blocks the heat from escaping. The thermal mass inside the building then absorbs this heat, both to prevent daytime overheating and to store it for nighttime. The proper ratio of mass to south-facing glazing is important.

Since in direct gain the building is the collector, all contents, such as the drywall, furniture, and books, act as thermal mass. However, the contents are usually not sufficient to store an adequate amount of heat without additional thermal mass. When there is no concrete floor or when even more thermal mass is desired, it can be provided in the walls, water containers, floors, or phase-change materials.

Although solar heat can be supplied by convection to the rooms on the north side of a building, it is much better to supply solar radiation directly by means of south-facing clear-story windows. Besides bringing warming sunlight further into the building, clear-stories also provide excellent day- lighting, because light from above is best.

Most direct-gain systems consist of straight walls facing due south or as close to south as possible. Direct gain is the most efficient when energy collection and first costs are the main concerns.

A Passive House / Building is a building standard that is energy efficient, comfortable, affordableand ecological ALL at the same time.

Passive House / Building is not a brand name, but a construction concept that can be applied by anyone and that has stood the test of practice and literally thousands of years of time. These are modern, beautiful, high-value homes.

Passive Buildings allow for heating and cooling related energy savings of up to 90% compared with typical building stock and over 75% compared with average new builds. In terms of heating oil, Passive Houses use less than 1.5 litres per square meter of living space per year – far less than typical low- energy buildings. Similar energy savings have been demonstrated in warm climates where buildings require more energy for cooling than for heating (thermal mass).

Passive Houses are also praised for their high level of comfort. They use energy sources inside the building such as using the heat from an oven or solar heat entering the building – making heating a lot easier.

Appropriate windows with good insulation and a building shell consisting of good insulated exterior thermal mass walls, roof and floor slab keep the heat during winter in the house – and keep it out during summer.

Ventilation consistently supplies fresh air making for superior air quality without causing any unpleasant draughts. This is a guarantee for low Radon levels and improves health conditions.

Cooling Tubes

Electricity free cooling based on ancient, global principles. These in-ground PVC cooling tubes are also known as air tubes, earth air tubes, a ground-coupled heat exchanger, an earth-air heat exchanger, thermal labyrinth, heat recovery ventilation, geothermal energy tubes, sustainability tubes, or a number of other terms.

Tire Offgassing Report – Non-Issue

This is a page to explain why building with tires is safe. The "off gases" are worst when tires are new. Old tires, buried in dirt and locked in concrete are safe for dwellings.

Picuris Global Model Earthship for Sale

They just keep getting better. Another amazing Earthship designed by renowned pioneer Mike Reynolds and built by the Earthship Biotecture team. This off

Covid-19 and Living Off-Grid in Earthships

The COVID-19 pandemic is highlighting the need for architecture to play by new rules. COVID-19 is causing dense, urban areas to lose their luster and making people rethink their lifestyles. Some are fleeing cities

Bottle Walls and the sun in Belize

Can & Bottle Walls A can wall is a wall constructed from recycled aluminum cans, which are not a common building source. The cans can be laid in concrete, similar to bricks to

Thermal Mass Walls

These walls systems are all solid walls made out of dense materials, of which the modern Brick, Block and poured concrete walls are the most common variety. Since these common variants are all have

3 ways to make old homes more sustainable and energy efficient

You don’t need to start from scratch to have a more efficient home. Find out how you can boost your home’s environmental credentials with some smart retrofits. Building regulations require today’s new homes to

Passive House

Passive House Buildings There is absolutely no cutting back on comfort; instead the level of comfort is considerably increased. A Passive House / Building is a building standard that is truly energy efficient, comfortable, affordable and ecological at

Earthship buildings are fire resistant, not a total loss.

The Question of how a structural earth-rammed tire wall would do in a fire has long been an issue for which we could only offer an intelligent opinion. People think that because tire piles in tire dumps burn so easily

Tire Retaining Walls

The same method for building structural walls in buildings can be applied when building retaining walls made with rammed earth encased in steel-belted rubber. Depending on the load the retaining wall is retaining, the batter

Load More Posts